SummaSign Pro T1010 Pro - Page 7

SummaSign Pro T-series Cutters User’ s Manual
Table of Contents TOC-ii
2. OPERATION
2.1. The control panel..........................................................................................2-1
2.1.1 The liquid crystal display..............................................................................2-2
2.1.2 The Reset/Load key......................................................................................2-2
2.1.3 The Online key..............................................................................................2-3
2.1.4 The Menu key...............................................................................................2-3
2.1.5 The Enter key.................................................................................................2-5
2.1.6 The 1 and 2 keys...........................................................................................2-5
2.1.7 The jogging keys...........................................................................................2-5
2.1.8 The Tool Up/Down key.................................................................................2-5
2.1.9 The Tool Select key.......................................................................................2-6
2.2. Normal Operation........................................................................................2-7
2.2.1 On line and off line......................................................................................2-7
2.2.2 Local operation............................................................................................2-8
2.3. The USER CONFIG menu..............................................................................2-9
2.3.1 Knife pressure..............................................................................................2-11
2.3.2 Pen pressure................................................................................................2-11
2.3.3 Pouncing pressure......................................................................................2-11
2.3.4 Knife offset...................................................................................................2-11
2.3.5 Pouncing gap.............................................................................................2-12
2.3.6 Velocity.......................................................................................................2-12
2.3.7 Overcut.......................................................................................................2-12
2.3.8 System setup...............................................................................................2-12
2.4. System setup...............................................................................................2-13
2.4.1 Concatenation...........................................................................................2-13
2.4.2 Smoothing ..................................................................................................2-13
2.4.3 Emulate ......................................................................................................2-13
2.4.4 Tool..............................................................................................................2-14
2.4.5 Menu units...................................................................................................2-14
2.4.6 Addressing..................................................................................................2-14
2.4.7 Baud rate....................................................................................................2-14
2.4.8 Parity............................................................................................................2-15
2.4.9 RTS/DTR........................................................................................................2-15
2.4.10 DM/PL errors................................................................................................2-16
2.4.11 HP/GL errrors...............................................................................................2-16
2.4.12 HP/GL origin .........................................................................................2-16
2.4.13 Media sensors.............................................................................................2-17
2.4.14 Autoload.....................................................................................................2-17
2.4.15 Tool command...........................................................................................2-17
2.4.16 LOAD ON W CMD.......................................................................................2-17
2.4.17 FLEX-CUT......................................................................................................2-18