SummaSign Pro T1010 Pro - Page 8

SummaSign Pro T-series Cutters User’ s Manual
Table of Contents TOC-iii
2.4.18 Recut offset.................................................................................................2-18
2.5. Internal test menu ......................................................................................2-19
2.5.1 Tangential knife calibration.......................................................................2-20
2.5.1.1 Adjust Origin test routine............................................................................2-22
2.5.1.2 Adjust Lat. test routine................................................................................2-23
2.5.1.3 Adjust Long test routine .............................................................................2-24
2.5.2 Cut border ..................................................................................................2-25
2.5.3 Menu plot....................................................................................................2-25
2.5.4 Confidence cut..........................................................................................2-26
2.5.5 DIN plot ......................................................................................................2-26
2.5.6 System tests ................................................................................................2-26
2.6 System tests.................................................................................................2-27
2.6.1 Language ..................................................................................................2-27
2.6.2 ROM revision ...............................................................................................2-27
2.6.3 Service plot .................................................................................................2-27
2.6.4 Sensor setup................................................................................................2-28
2.6.5 Calibration ..................................................................................................2-28
2.6.6 Tracking test ................................................................................................2-28
2.6.7 Friction plot .................................................................................................2-28
2.6.8 RS232 test ....................................................................................................2-28
2.6.9 RAM test ......................................................................................................2-29
2.6.10 Install menu ................................................................................................2-29
2.6.11 Setup coil ....................................................................................................2-29
2.6.12 LCD contrast ...............................................................................................2-29
3. MAINTENANCE AND CLEANING
3.1. Maintenance ................................................................................................3-1
3.1.1 Cleaning the drive system...........................................................................3-1
3.1.2 Cleaning the sensors....................................................................................3-2
3.1.3 Cleaning the nose piece.............................................................................3-3
3.2. Operating voltage conversion ....................................................................3-4
4. INTERFACE
4.1. Introduction...................................................................................................4-1
4.2. Interface notes..............................................................................................4-1
4.2.1 System setup.................................................................................................4-1
4.2.1.1 MS-DOS or PC-DOS generating system......................................................4-1
4.2.1.2 Windows 3.xx.................................................................................................4-2
4.2.1.3 Windows 95...................................................................................................4-2