SummaSign Pro T1010 Pro - Page 9

SummaSign Pro T-series Cutters User’ s Manual
Table of Contents TOC-iv
4.2.2 Serial interface connector on cutter..........................................................4-3
4.2.3 Parallel interface connector on cutter ......................................................4-3
4.3. Available serial signals ................................................................................4-4
5 CONTOUR CUTTING
5.1 Introduction...................................................................................................5-1
5.2 General (see section 6 for the actual procedure details) ........................5-5
5.3 Creating the design .....................................................................................5-5
5.4 Placing the Cross-marks..............................................................................5-6
5.5 Printing the design........................................................................................5-7
5.6 Loading the cutter and setting the parameters .........................................5-8
5.7 Registrating the cross-marks .......................................................................5-9
5.8 Cutting the contour ....................................................................................5-11
APPENDIX A:
Media certification ...................................................................................... A-1
LIST OF ILLUSTRATIONS
1-1 SummaSign Pro T-series cutter, rear view.................................................1-10
1-2 SummaSign Pro T-series cutter, front view ................................................1-12
1-3 Earth connection........................................................................................1-15
1-4 Standard knife assembly ...........................................................................1-16
1-5 Nose piece installation ..............................................................................1-17
1-6 Knife holder insertion..................................................................................1-17
1-7 Knife depth adjustment .............................................................................1-18
1-8 Knife depth test pattern.............................................................................1-19
1-9 Sandblast knife assembly ......................................................................... 1-20
1-10 Nose piece and knife installtion for cutting masking stencils or
heavy materials..........................................................................................1-21
1-11 Drag knife assembly...................................................................................1-22
1-12 Drag knife holder insertion.........................................................................1-22
1-13 Ballpoint pen assembly .............................................................................1-23
1-14 Ballpoint holder insertion ...........................................................................1-24