Index-5
P
package contents, 3-3
checking, 3-3
parameters
serial port, 4-19
physical drive
size and speed, 8-8
status, 8-8
physical drive capacity setting, 6-25
planning site, 2-1
ports
connecting (see cabling), 4-1
power and fan module
description, 1-8
power LED, 7-3
power outlets
connecting to AC, 4-7
connecting to DC, 4-8
power specifications, 2-4
powering up an array, 4-10
Powering Up and Checking LEDs, 4-10
power-off procedure, 4-30
power-on sequence, 4-29
preinstallation worksheet, 2-7
preparing for logical drives larger than 253
Gbyte, 6-17
probe-scsi-all command, 6-35
Product and Architecture Overview, 1-1
protocols
Fibre Channel, 1-9
Q
quick installation (not applicable), 8-2
R
rack-mounting an array
cabinet-mounting an array, 3-5
RAID (1+0)
concurrent rebuild in, 9-7
RAID (5+0), 6-16
RAID level assignment, 6-24
RAID levels
defined, 6-15
selected, 6-23
RAID levels defined, 6-15
random I/O optimization
maximum size, 6-12
RARP, 4-20
Rear-Panel LEDs, 7-4
rebuild
automatic, 9-3
concurrent in RAID (1+0), 9-7
manual, 9-6
Rebuilding Logical Drives, 9-3
Recovering From Fatal Drive Failure, 9-11
redundant controller
explained, 9-2
release notes, 1-13
remote file, F-3
requirements
environmental, 2-3
Reset button, 8-5
reset button
silencing failed component alarms, 8-4
Restoring Your Configuration (NVRAM) From a
File, 8-20
RS-232
connecting to, 4-19, G-2, J-3
upgrading firmware via, 8-24
S
safety precautions, 2-2
SB-MISS drive status, 8-9
SCSI channel status, 8-10
SCSI drive
global or local spare, 8-9
STANDBY mode, 8-9
USED DRV mode, 8-9
vendor ID, 8-9
SCSI drive status, 8-8
sequential I/O optimization
maximum size, 6-12
serial cable
null modem, 4-19
serial port
parameters, 4-19
To Next Page
Loading...
