viii Sun StorEdge 3000 Family Installation, Operation, and Service Manual • May 2004
8. Maintaining Your Array 8–1
8.1 Quick Installation (Reserved) 8–2
8.2 Battery Operation 8–2
8.2.1 Battery Status 8–2
8.3 Silencing Audible Alarms 8–4
8.4 Checking Status Windows 8–6
8.4.1 Logical Drive Status Table 8–6
8.4.2 Physical Drive Status Table 8–8
8.4.3 Channel Status Table 8–10
8.4.4 Controller Voltage Temperature Status 8–13
8.4.4.1 View Controller Voltage and Temperature Status 8–13
8.4.4.2 Configure a Trigger Threshold 8–13
8.4.5 Viewing SES Status 8–15
8.4.6 SES Temperature Sensor Locations 8–16
8.4.7 Identifying Fans 8–17
8.4.8 Viewing Event Logs on the Screen 8–18
8.5 Restoring Your Configuration (NVRAM) From Disk 8–20
8.6 Upgrading Firmware 8–22
8.6.1 Patch Downloads 8–23
8.6.2 Installing Firmware Upgrades 8–23
8.6.3 Controller Firmware Upgrade Features 8–24
8.6.4 Installing Controller Firmware Upgrades From the Firmware
Application (Windows Only) 8–25
8.6.4.1 Install Boot Record and Firmware Binary 8–25
8.6.4.2 Install Firmware Binary Only 8–25
8.6.5 Upgrading SES and PLD Firmware 8–26
8.7 Replacing the Front Bezel and Ear Caps 8–26
8.7.1 Removing the Front Bezel and Ear Caps 8–26
8.7.2 Placing the Bezel and Ear Caps Back Onto the Chassis 8–27
To Next Page
Loading...
Need help?
General
