SINGLE PHASE HI 10/12kW | User Manual38
Set a number in the auto dim box to dim the
LCD after a number of seconds.
How to set the auto dim:
How to turn the beep on or o:
Check or uncheck the beep box and the press
OK to congure it as you prefer.
Factory Reset and Lock Code
To access the Settings, click on the gear icon on the right top of the menu.
Reset status.
Whether the ‘lock code’ is used or not.
What this page displays:
Reset the inverter to the factory settings.
System diagnostics.
Change or set the ‘lock code’.
What you can do from this page:
Factory Reset: Reset all parameters of the inverter
Lock out all changes: Enable this menu to set parameters before the unit is locked and cannot be reset.
*Before performing a successful ‘Factory Reset’ and locking the systems, the user must enter a
password to allow the setting to take place. The password for ‘Factory Reset’ is 9999 and for
lockout is 7777.
System self-check: Allows the user to conduct a system diagnosis. After ticking this item, it needs input
the password. The default password is 1234
Locked Inverter: This function is used to lock the inverter completely so no access can be gained. It will
ask for a 5-digit code that only the Sunsynk Technical sta can assist with.
Test mode (only for engineers): For engineers to conduct tests.
8.8
kWh
5.6
kWh
7.5
kWh
2.20
Hours
8.8
kWh
85%
Battery IN/OUT MPPT. GRID
Solar/Turbine AC load
Battery Grid
To Next Page
Loading...
Need help?
General