EasyManuals Logo

SunSynk SUNSYNK-10K-SG02LP1 User Manual

SunSynk SUNSYNK-10K-SG02LP1
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
SINGLE PHASE HI 10/12kW | User Manual45
Therefore, if a communication error occurs:
1. Check that your data cable is the correct type.
2. Check that the data cable is plugged into the correct sockets. Usually, RS485 is employed, but some
battery manufacturers use others.
NOTE:
With some types of lithium batteries, the BMS cannot be controlled by the Sunsynk inverter. In this
case, treat the battery as a lead-acid type and set the charging and discharging protocol following the
battery manufacturer's specications.
It is crucial to refer to the manuals that manufacturers produce for their batteries. That way, the chance of
errors occurring during installation is signicantly reduced. Below is a list of batteries that have been exam-
ined, tested, and approved by Sunsynk.
Brand Model
48V
Storage
Inverter
RS485
or CAN
Inverter
Setup
Notes
DYNESS
B4850
CAN
0
POWERBOXF 0
SunketESS LFP5000
CAN 0
Osily LFP5KWH/LV
CAN 0
HUBBLE AM-2 5.5KW
CAN 0
SACRED SUN
SSIF2P15S48100C
RS485 1
Cut Line 3, 6, 8FCIFP48100A RS485 1
SSIFP48100A RS485 1
SolarMD
SS4074
CAN
0
To be used with V2 Logger
http://solarmd.co.za/invert-
er-compatibility-solarmd/
sunsynk-and-solar-md/
SS4037 0
SS202 0
SHOTO SDC-Box5(5.12KWH)
CAN 0
What you can do from this page:
Set up you Lithium-ion battery.
After installing a lithium battery, check the communications page by clicking on the ‘Li BMS’ icon to see if
the BMS information is visible. Suppose some information is not displayed correctly (it should look like the
diagram below), then there will be a communication error.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SunSynk SUNSYNK-10K-SG02LP1 and is the answer not in the manual?

SunSynk SUNSYNK-10K-SG02LP1 Specifications

General IconGeneral
BrandSunSynk
ModelSUNSYNK-10K-SG02LP1
CategoryInverter
LanguageEnglish

Related product manuals