SUNWARD SWE90UF-2PB - Page 15

SWE90UF-2PB Operation & Maintenance Manual
6
 Open right side door to check oil level gauge.
Located on hydraulic oil tank, oil level must be within
level marks. Drain oil if level is higher than MAX mark,
refill if level is below MIN mark.
 Fill oil：
 Remove upper breather screw cap by rotating
anticlockwise.
 Refill oil through strainer. Recheck oil level gauge.
 Fasten cap securely.
(5) Maintenance and Lubrication Label
Proper procedure of maintenance and inspection
Learn about how to properly service machine. Perform
proper maintenance and inspection procedure in
accordance with this manual. Inspect machine before
starting machine.
 Check monitor.
 Check each liquid level.
 Check hose and piping for leakage, twist, wear out or
damage.
 Check surrounding the machine for any signs of noise,
heat etc.
 Check parts for looseness and lost.
Caution
 If any problems are detected, repair prior to
operation, or contact our authorized
distributor.
 Use recommended fuel, hydraulic oil and lubricant.
 Use only genuine SUNWARD components.
 The warranty is not applicable for any damages