SWE90UF-2PB Operation & Maintenance Manual
Weight support adjustment: adjust load bearing
capacity of seat in relation to your weight for better
damping effect.
1.2.11 Fastening Seatbelt
Check seatbelt for damage or wear out before
starting machine.
Fasten your seat belt prior to operation.
Change seat belt every 3 years to ensure the safety
performance of seat belt can meet the requirements
for use.
1.2.12 Ensuring Perfect Visibility
Stop the machine if the fog, rain, snow or dust has negative effects on your visibility.
To work at dark, make sure the lighting device can function normally.
1.2.13 Leaving Operation Seat Safely
Warning: Unexpectedly touching unlocked pilot safety control lever can result in sudden
movement of the machine and cause injury or damages to the machine.
When operator tends to leave or stand up off the seat( to open or close front or upper windows,
remove or install front lower windows, adjust seat), please lower the work equipment to the ground,
set pilot safety control lever to LOCK position securely, then stop the engine.
1.2.14 Emergency Exit
If the door cannot be opened for some reason, you may open the back windows, and use it as an
alternative exit way for emergency. For details refer to the instructions in “emergency exit label”.
1.2.15 No Passengers Allowed
When machine is in the process of operation or
traveling, do not allow anyone to ride on the
machine other than the operator. Because there is a
hazard that passengers may fall off or get hit by
foreign body.
Passenger may block operator’s sight to result in
unsafe operation.
Do not allow anyone to sit on bucket or other front attachments. Serious injury can occur to person.
To Next Page
Loading...
