SWE90UF-2PB Operation & Maintenance Manual
When traveling, swing, operating working device in
confined area, position a signal person and define the
meaning of the signals beforehand.
1.3.12 Safety Rules During Traveling
During operation of machine, do not operate
exceeding max load capacity or performance to avoid
stall and damage to working device.
When traveling on flat ground, fold the working
device and keep 400 to 500mm high above the
ground.
When traveling on rough ground, travel at low speed.
Do not steer sharply ， there is a risk of machine
turning over. The work device may hit the ground and
cause machine to lose its balance or damage the
machine or structures.
When traveling on rough ground or on slope, disable
the auto-reduction switch( if present) ， if
auto-reduction switch is on, engine revs may increase.
This may cause machine to speed up abruptly.
Avoid traveling on obstacles if possible. if the
machine has to travel on obstacles, lower the working
device close to the ground at low speed. Do not
travel over obstacles which involve risk of tilting
machine to one side.
When traveling or operating, keep a safe distance
from people, structure or other machine to avoid
making contact with them.
When passing over bridges or structures, check first
structure is strong enough to support the weight of
the machine. When traveling on road, contact
relevant authorities and follow there instructions.
When operating in tunnel, under bridges, under
electric wires or other height-limited area, operate
slowly and pay much attention not to hit anything.
To Next Page
Loading...
