SUNWARD SWE90UF-2PB - Preventing Accidents While Backing or Swinging

SWE90UF-2PB Operation & Maintenance Manual
29
 Lower operation speed to prevent machine from
tipping over.
 Do not change direction when tramping on a
slope.
 Decrease slewing speed of upper-structure, when
bucket is loaded.
 Be alert that ground surface becomes soft arising
from increase of ambient temperature. This may
affect the stability of machine.
1.3.9 Preventing Accidents While Backing or Swinging
Warning: There is a possibility to crush or hit
person around to cause severe accidents of injury or
death, when swing or reversing the machine.
Follow the following instructions to prevent accidents
during swing or reversing operation.
 Check surrounding area to ensure there is no other
person around before swing and reversing the
machine.
 Ensure that bystanders are out of swing area.
 Ensure that travel alarm is functioning properly. Be
alert that no bystander accesses to jobsite. Sound
horn or use other alarm to warn people.
 When machine travels in reverse, provide a flagman
to assist in case operator’s sight is limited. Keep the
flagman with operator’s sight
 When signal is needed during working, signal man be
suppose to use hand signal. Only when the signals
are understood by both signal man and operator, the
machine can be operated to tram or swing.
 Understand all flags, signs and signals being used
during operation. Select the person who is
responsible to signal.
 Keep windows, mirrors and light fittings clean.