SWE90UF-2PB Operation & Maintenance Manual
1.2.25 Prevention of Flying-Out Parts
Bear in mind that lubricating grease in track tension
device is under high pressure. Do not remove parts
such as oil cup or valve etc to avoid injury.
Moreover, keep face and body away from valve block
in case that part will fly out.
There is some pressure build up in travel redactor. Gear oil
temperature will increase after operation. Keep face and body
away from air bleeding plug.
With gear oil cooled, gradually loosen air bleeding plug to
release pressure.
1.2.26 Preventing Asbestos Dust Inhalation
Asbestos dust is known to cause pulmonary cancer.
When handling elements containing asbestos fibers,
be cautious not to inhale asbestos dust generating by
those elements.
To avoid dust, do not use pressurized air to clean
machine. Do not scrub or grind material containing
asbestos. Always wear approved respirator and use
recommended dust collector to remove asbestos
during maintenance. If you can not find them, wet
asbestos material with water or oil. Follow rules and
regulations at operational site. Observe relevant laws
and regulations in reference to asbestos disposal. Do
not allow other person to access working area.
1.2.27 Preventing Inhalation of Smoke or Exhaust Gas
If exhaust gas is inhaled, this can cause diseases and
even death.
If machine is operated at indoor, it’s necessary to
open door and windows to ventilate. Or you can also
use lengthened discharge pipe to discharge exhaust
gas to outside.
To Next Page
Loading...
