SWE90UF-2PB Operation & Maintenance Manual
Stop the engine, remove the key and lock cab doors
and windows securely.
Use steel rope and support rod with sufficient length to
keep them not to hit machine during lifting operation.
Cover steel rope or rod with protective material to
avoid damages to machine if necessary.
Put steel ropes through the place between the first and
second track rollers on both side of the machine.
Adjust steel rope to keep the lifting angle within 30° to
40°.
Lifting the machine gradually, check that it’s balanced.
Make sure to keep machine at level, otherwise re-adjust
steel rope until it’s at level.
2.2 STORAGE
Note
To protect the hydraulic cylinder piston rod while
in storage, keep the work equipment in the fig
shown at right. (This prevents rust from
developing on the piston rod).
2.2.1 Before Storage
Clean and wash all surface and exposed parts.
Apply grease to all lubricating parts until fresh grease
spills out.
Change engine oil.
Apply grease to exposed parts on piston rod.
Top up fuel tank with diesel oil.
Disconnect battery negative terminal and secure battery
cover. You can also remove the battery from the
machine, store it separately.
If the expected ambient temperature may below 0°C
(32°F), mix coolant with anti-freezing liquid.
Select proper storage position
：
The machine must be
kept at well-ventilated indoor place, if the machine has
To Next Page
Loading...
