SWE90UF-2PB Operation & Maintenance Manual
1.3 SAFE OPERATION INSTRUCTIONS
1.3.1 Inspection before Starting Engine
Before starting daily routine inspection, carry out the
following checks.
Wipe off dust on glass window to secure visual field.
Wipe off dust on the surface of front light and
working lamp, check to ensure they are properly
functioning.
Check coolant level, fuel level and oil level in engine
oil pan. Check air filter for clogging, check wiring for
damage.
Adjust operator’s seat to a position where it is easy
to carry out operation. Check seat belt or mounting
clamps for damage or wear.
Check meters to ensure they are functioning properly.
Check working lamp angle. Make sure control levers
are at neutral position.
Check safe lock control levers to ensure they are in
LOCK (UP) position before starting engine.
Adjust rear view mirror to a certain position where a
clear visual field of back machine is secured.
Check upper or lower machine to ensure there is no other
persons or obstacles surrounding machine.
In case there are any warning tags posted on control lever, do
not start or touch control lever.
1.3.2 Correct Engine Start-up
Warning: Inappropriate engine start can cause machine out
of control leading to severe injury or death.
Make sure all control levers are set in neutral position, and
honk the horn to alert, before starting engine.
Start the engine only if operator is in seated position. Do not
To Next Page
Loading...
