SWE90UF-2PB Operation & Maintenance Manual
Set travel speed at low position. Do not
attempt any travel speed switching operation to
avoid that sharp change of speed and over-speed
cause danger. Always keep the machine travel at
low speed.
Be sure engine runs at low speed, adjust
throttling knob to keep the engine run at low
speed.
When loading or unloading, do not attempt
any steering operation. At which moment, steering
operation is extremely dangerous. The machine is
subject to rolling over. If the machine needs to
change direction, go back to level ground or trailer
platform, then revise travel direction and cross the
slope.
Do not attempt any other operations (e.g.
steering and moving work equipment etc) on slope.
Allow only travel operation.
Because it’s a raised shape at the place where
ramp intersects the flats. Pay attention to pass it:
the slope should not exceed 15
°
.
Prevent the machine from tipping over and
other damages due to upper-structure slewing.
Lower the boom, fold arm and bucket and slew the
upper-structure slowly to get the optimum
stability.
Clean up the track, slope of the trailer and
loading surface to prevent hazards resulting from
obstacle and oil
To Next Page
Loading...
