SWE90UF-2PB Operation & Maintenance Manual
(4) As figure 4.10.1 shows, turn the wind speed switch to OFF to shut down the system.
Heating Operation
(1) Choose proper wind speed and direction according to the “aeration operation”.
(2) As FIG 4.10.1 shows, turn the main switch to a proper position in red area. (Anticlockwise turn for lower
temperature; turn clockwise to the far right for the highest temperature; If it’s too hot, turn anticlockwise
properly to increase the temperature; Furthermore, the hot temperature is also can be adjusted by the wind
speed.)
(3) You can get a comfortable environment by controlling the wind speed, wind direction and the
temperature.
Special Operation
1
. Strong refrigeration operation
When it is very hot, especially a period of time after just turning on the air conditioner, you should choose
this operation. That is: choose refrigeration pattern, press “wind speed increasing button” to choose the
highest wind speed, press “set increasing button” to choose the lowest temperature.
2 . Weak refrigeration operation
When it is slightly hot, especially the period of time after turning on air conditioner, the indoor temperature
is suitable or even a little cool, you should choose this operation. That is: choose refrigeration pattern, press
“wind speed decreasing button” to choose the lowest wind speed, press “set decreasing button” to
choose a lower temperature.
3
. Strong heating operation
When it is very cold, especially the period of time after just turning on the heater, it is cold inside the vehicle
or sometimes there is frost, snow which needs removing, you should choose this operation. That is: choose
heating pattern, press “wind speed increasing button” to choose the highest wind speed, press “set
increasing button” to choose the highest temperature.
4
. Weak heating operation
When it is slightly cold, especially the period of time after turning on the heater, the indoor temperature is
suitable or slightly warm, you should choose this operation. That is: choose heating pattern, press “wind
speed decreasing button” to choose the lowest wind speed, press “set decreasing button” to choose
To Next Page
Loading...
