9
In case fingerprint is not recognized normally
Cautions while registering your fingerprint
BioLite Net is designed to normally operate regardless of weather change or the
angle and location of the fingerprint to place.
However, the recognition rate may vary depending on the external environment or
fingerprint condition.
In abnormal cases, follow the directions below:
1. Retry after drying the wetness of your finger.
2. When your finger is too dry, retry after blowing on your fingertip.
3. When you have a cut on your registered finger, register another fingerprint.
The initial fingerprint registration is important.
Because the recognition process compares the scanned fingerprint with the
registered one, an abnormally registered fingerprint can cause a failure.
To increase the recognition rate, follow the directions below:
1. Put the center of your fingerprint on the middle of the sensor.
2. If you have a cut in your finger or your fingerprint is not clear enough, retry with
another finger.
3. When fingerprint recognition is in progress, do not move your fingerprint .
To Next Page
