suprema BioLite Net - Page 47

46
※ Methods
- PC Conn.: Directly connects to PC through RS485
- Host/Slave: Connects between terminals through RS485. Used when the terminal
interoperates with the BioAdmin software.
(Refer to the BioAdmin manual.)
- Ext. Host/Ext. Slave: Connects between terminals through RS485. Used when
the terminal interoperates with the BioStar software.
(Refer to the BioStar manual.)
- Termination: Used when the communication line is too long or the signal strength
changes drastically (It enforces the signal strength).
- Host/Slave, Ext. Host/Ext. Slave: Connects between terminals through RS485.
The communication speed is fixed to
115200 baudrate.
The completion
message window
appea
r
s
.
Completed
Use / buttons to ◀▶ set
whether or not to use the
termination and press OK.
The completion
message window
appears.
Type
Ext. Slave
Serial Conn .
Termination
Not Use
Serial Conn.
Completed
Use / buttons to◀▶ set
whether or not to use the
termination and press
The completion
message window
appears.
Type
Not Use
Serial Conn.
Termination
Not Use
Serial Conn
Completed
Use / buttons to◀▶
set whether or not to
use the termination
and
p
ress O
K
.
Baudrate
115200
Serial Conn .
Type
PC Conn .
Serial Conn .
Termination
Not Use
Serial Conn.
Use ◀/▶ buttons to
select Ext. Slave and
p
ress O
K
.
Use ◀/▶ buttons to
select Not Use and press
O
K
.
Use ◀/▶ buttons to
select PC Conn. and
p
ress O
K
.
Use ◀/▶ buttons to
select Baudrate and press
OK.
*115200/57600/38400
/19200