Supvan TP76E - Page 42

SUPVAN Chapter 5 Operation of Function Key
42
All half-cut depths of initial state are at the position of ”0”.
5.21.1 Press【Cut Depth】, it will display as below:
5.21.2 Adjustment of tube Half cut depth
Press【↑】or【↓】to select the model of pre-adjusted tube. If selecting 4.0,
press【Enter】, it will display as below:
20
4
Y
N
1
4
6mm Label
9mm Label
12mm Label
1.0 Tube
4.0 Tube
6.0 Tube
Shrink tube