120
(4) Install front propeller nut (5), using special tool to reach
specified torque.
NOTE:
Front propeller nut is LH (Left Hand) thread.
Front propeller nut (a): 130 N·m (13.0 kgf-m, 94.0 lbf-ft)
(A): 09923-29810: Propeller nut installation/removal
tool
(5) Bend the propeller nut stopper tabs toward nut to secure
nut.
NOTE:
Two tabs must be bent to secure.
Rear propeller:
(6) Install rear propeller stopper (6) onto propeller shaft, then
slide on the rear propeller (7).
(7) Fit spacer (8), washer (9) and nut (10), then tighten nut to
specified torque.
(8) Push cotter pin (11) through nut and shaft, then bend to
secure.
Rear propeller nut (b): 55 N·m (5.5 kgf-m, 40.0 lbf-ft)
6
7
11
10
(b)
8
9
To Next Page
Loading...
