72
(5) The following window appears. Check that the calibration are correct, click the “OK” button, and pro-
ceed to the next step (“Enter” key on the keyboard).
Clicking the “Cancel” button brings you back to the previous window.
(6) The following window appears. This window is used to register the outboard motor position in the BCM.
Operate the PTT switch of the outboard motor to perform full tilt down.
Click the “OK” button to have the outboard motor position accepted and proceed to the next step.
(Figure is an example of registering the PORT outboard motor.)
Clicking the “Cancel” button cancels system calibration.
NOTE:
• For the dual engines, register the PORT and STBD positions. For triple engines, register the PORT, CEN-
TER, and STBD positions.
• After full tilt down, the high-pressure fuel pump of the outboard motor is actuated for 3 seconds. Listen for
the actuation sound.
To Next Page
Loading...
