79
(2) Clicking the “SYSTEM FORMATION” button from the menu
window displays the window.
The upper part of this window illustrates the system config-
uration registered in the BCM.
The following figure shows a dual station of triple outboard
motor type.
The lower part of this window shows the master BCM ID,
sub BCM ID, PORT ECM ID, CENTER ECM ID, and STBD
ECM ID.
Click the “OK” button to terminate system check.
NOTE:
If the illustration and description of the displayed system config-
uration differ from the registered configuration and the configu-
ration of actual boat, it means that the system is not correctly
calibrate.
In this case, be sure to calibrate the system.
To Next Page
Loading...
