50
B’K’
N’
/
/
/
/
/
/
/
A’L’
G’
/
/
F’E’
20
BCM
J/C
J/C
The structure of the system components and wiring
are basically the same as for the single engine.
However, the following items are added for triple engines:
1) Disconnect the resistor (1) from keyless CAN harness.
2) Connect the CAN extension harness connector
to connector which the resistor was attached.
3) Connect the other end of CAN extension harness
to CAN harness connector of engine main harness
for center engine.
4) Connect the CAN extension harness to engine main
harness for PORT engine.
5) Connect the resistor (1) to CAN extension harness as shown.
Resistor (1)
CAN extension
harness
(P/no. 36664-96L00)
CAN extension
harness
(P/no. 36664-96L00)
STBD
Resistor (1)
STBD
Center
PORT
To Next Page
Loading...
