STBD
STBD center
PORT center
50
B’K’
N’
/
/
/
/
/
/
/
A’L’
G’
/
/
F’E’
20
BCM
J/C
J/C
The structure of the system components and wiring
are basically the same as for the single engine.
However, the following items are added for quadruple engines.
1) Disconnect the resistor (1) from keyless CAN harness.
2) Connect the CAN extension harness connector
to connector which the resistor was attached.
3) Connect the other end of CAN extension harness
to CAN harness connector of engine main harness
for STBD center engine.
4) Connect the CAN extension harness to engine
main harness for PORT center and PORT engines
as shown.
5) Connect the resistor (1) to CAN extension harness as shown.
Resistor (1)
CAN extension
harness
(P/no. 36664-96L00)
CAN extension
harness
(P/no. 36664-
96L00)
STBD
Resistor (1)
CAN
extension
harness
(P/no. 36664-
96L00)
PORT
To Next Page
Loading...
