.....
[] Basic Connection
Thissectiondescribeshowto connectthe unit toan antenna, cable/sateJlJtebox,etc.
Note:
. Besure your antenna or other device is connected properly before pluqqinq in the power cord.
[Antenna Cable Connection]
When connecting the unit to an antenna or cable TV company (without cable/satellite box)
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.
e.g.)
VHF/UHF_
antenna _
rear of this unit
RF coaxial cable
cableTV
company
*Once connections are completed, turn on the unit and begin initial setup,
Channel scanning is necessary for the unit to memorize all available channels in your area.
(Refer to"Initial Setup"on page 11 .)
Note:
. Foryour safety and to avoid damage to device,please unplug the RFcoaxial cable from the an tenna inputjack before moving the unit.
. If you use an antenna to receive analog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
. Toeasily switch your reception source between antenna and cable, install an antenna selector.
. fyou connect to the cable system directly, con tact the CATVinstaller.
[Connection to Cable Box or Satellite Box]
Connect the RF coaxial cable on your home outlet to the input jack of the cable/satellite box.
Use another RFcoaxial cable to connect the antenna input jack of the unit to the output jack of the cable/satellite box.
e.g.) rear of this unit
cable/satellite box
satellite
dish
cable TV RFcoaxial cable
company
*Required cables and connecting methods differ depending on the cable/satellite box.
For more information, please contact your cable/satellite provider.
if!
iO
i C
Z
i ¸i i
SK_
G
i lili!!!
U_
EN
To Next Page
Loading...
