Spill to target of material 4
Zero range (00~99 represent 0.0%F.S. ~9.9%F.S.)
Auto spill correction frequency
Dump over output close delay time
Read only(refer to last table)
Numbers of finished batches. (write 0 to clear total weight and
batches)
F6.4 feeding tolerance checking frequency 0-99
F6.4A target tolerance range (00~99 represent 0.0%F.S. ~9.9%F.S.)
F6.8 numbers of batching material
Material 1 total consumption (high word) (read only)
Material 1 total consumption (low word) (read only)
Material 2 total consumption (high word) (read only)
Material 2 total consumption (low word) (read only)
Material 3 total consumption (high word) (read only)
Material 3 total consumption (low word) (read only)
Material 4 total consumption (high word) (read only)
Material 4 total consumption (low word) (read only)
F6.9.1 Material 1 feed speed
F6.9.2 Material 2 feed speed
F6.9.3 Material 3 feed speed
F6.9.4 Material 4 feed speed
F6.10 1: continue last batch on power up; 0: abort last batch on
powerup.
F6.11 batch mode: 0: mix batching; 1: cycle batching
Preset numbers of batches.
Numbers of finished batches. (write 0 to clear total weight and
batches)
To Next Page
Loading...
Need help?
General