EasyManua.ls Logo

Syn-Tech Systems FuelMaster Plus - Section I: Vehicle Key Operations (Continued); Odometer Entry Errors and Writing to Key

Default Icon
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION I - VEHICLE KEY OPERATIONS
13
This error message indicates that the entry made is lower than the entry
that was written to the key during the previous fueling transaction on this
vehicle.
***** FUELMASTER ****
* ODOMETER TOO HIGH! PLEASE TRY AGAIN. *
This error message indicates that the entry has an elapsed miles or hours value
that is greater than the MILES/HOURS range encoded on the key. One of the
following may have occurred:
The miles/hours range on the key was too low to begin with.
Tenths of miles are being entered when only whole miles should be
entered.
The last time the key was used, the miles/hours not written back to the
key.
The entry was incorrect and not confirmed before pressing the
ENTER/YES key on the keypad.
The entry is correct but the vehicle's last fueling was off-site causing
the miles/hours range to be exceeded.
Any of the above error messages requires re-entry of the miles or hours. The
standard FMU accepts the user's second mile/hour entry, regardless of accuracy.
The following screen will be displayed:
** REINSERT YOUR VEHICLE KEY **
** TO CONTINUE **
The following message indicates that the miles/hours entered was accepted and
the FMU wishes to write the entry back to the key. Insert the Vehicle Key and
hold it in. Note: The following display is quickly displayed notifying the user that
the entry is being written to the key:
** FUELMASTER **
** WRITING ODOMETER TO KEY **
If the ‘Bad Odom Termination’ option is enabled on the FMU, the
following display appears upon entry of two consecutive odometer
entries which are out of range of the odometer read from the key.

Table of Contents

Related product manuals