SECTION I - VEHICLE KEY OPERATIONS
14
** TRANSACTION CANCELLED BECAUSE OF **
** OUT-OF-RANGE ODOMETER ENTRIES **
If the Preventive Maintenance option is enabled, the following prompt will
appear if vehicle is due for service:
** VEHICLE IS DUE FOR PREVENTATIVE **
** MAINTENANCE -- INFORM SUPERVISOR! **
This message serves as notification that the PM (preventative maintenance)
MILEAGE encoded on the key has been reached, and preventive maintenance is
due. This message continues to be displayed for this vehicle until the Vehicle
Key is updated (PM MILEAGE is reset) by the supervisor. (This message is
displayed for the time period specified in the Configuration Setting, ‘Message
Read Duration’. The default for this setting is 4 seconds.)
If the Oil Check option is enabled on the system, the following prompt will
appear:
***** FUELMASTER ****
DID YOU CHECK YOUR OIL? (Y/N) --->
This prompt requires that you press the ‘YES’ or ‘NO’ key on the FMU keypad
based on whether the oil has been checked at the time of this fueling transaction.
Pressing ‘YES’ prompts the following display:
***** FUELMASTER ****
ENTER OIL QTY ADDED (QUARTS) --->
This prompt requires entry of a single digit between 0 and 9 (there
is an option to enter a two digit number if need be) on the FMU
keypad. Enter the number of quarts of oil added at the time of this
transaction and press <ENTER>.
NOTE:
The oil check transaction will appear as a separate transaction on
the FMU’s on-site printer and in the Central Controller’s transaction
listing and will appear at the bottom of the fuel transaction receipt.
This feature is provided as an additional record-keeping capability
of FuelMaster systems.
To Next Page
Loading...