TA I
NSTRUMENTS
DSC A
UTOSAMPLER
CE 6–21
Autosampler CE Test Functions
t
CAUTION:
The Autosampler CE screen displays:
Test
Motion
3. Press ENTER to select the test displayed on
the screen. The screen displays:
Motion
Test
4. Press any of the motion keys. The motor
continues to run even when the turret
assembly reaches an obstacle. Note that the
GRIP and RELEASE keys move the fingers
incrementally instead of fully opening and
closing them in single keystrokes.
Once the turret stops moving, release the
motion key. Do not attempt to continue motion
once the motor stalls against an internal
mechanical stop.
5. Press ESCAPE/CLEAR to exit the Motion
test.
When you have finished using the Autosampler
CE keypad, remember to close the keypad cover
and finger-tighten the thumbscrews before
starting a method.
NOTE:
To Next Page
Loading...