EasyManua.ls Logo

TA Instruments DSC Autosampler CE User Manual

TA Instruments DSC Autosampler CE
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background image
Introducing the DSC Autosampler CE
TA I
NSTRUMENTS
DSC A
UTOSAMPLER
CE1–6
The Autosampler CE can be used with the
full range of thermal analysis temperature
profiles currently used in manual
experiments (depending upon the cooling
accessory installed).
The AS run sequence ensures that the DSC
cell is within a safe load temperature range
(10 to 100
o
C) at the beginning of each run
by using compressed ambient air to rapidly
cool or warm the DSC cell as needed. You
can further narrow this temperature range if
you wish when you create your AS run
sequence.
The Autosampler CE log keeps a record of
all controller and Autosampler CE activities
so that you can review operations even after
they are performed.
The Autosampler CE runs a series of
diagnostics tests at power-up and
continuously during operation to ensure that
all mechanical and electrical components are
operating properly.

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the TA Instruments DSC Autosampler CE and is the answer not in the manual?

TA Instruments DSC Autosampler CE Specifications

General IconGeneral
BrandTA Instruments
ModelDSC Autosampler CE
CategoryLaboratory Equipment
LanguageEnglish

Summary

Safety, Introduction, and Preparation

Safety and Handling Precautions

Notes, cautions, warnings, CE compliance, and safe lifting procedures.

Introduction to DSC Autosampler CE

Overview, features, components, system relationship, requirements, and terminology.

Initial Setup and Preparation

Steps for unpacking, connecting, installing lids, and dust cover.

Operation, Calibration, and Diagnostics

Manual Mode Operation

Using the autosampler in manual mode: starting, mode switching, turret control, pan handling.

Calibration Procedures and Tests

Step-by-step guide for calibrating positions and performing diagnostic tests.

Diagnostics and Error Handling

Performing diagnostic tests and resolving error messages.

Sample Preparation and Reference

Sample Preparation

Installing crimping die, setting up tray, preparing sample pans (crimped/hermetic).

Reference Information

Lists of parts, supplies, ordering information, and document index.

Related product manuals