TAJIMA TEHX-C - Page 5

CONTENTS
10. ROTATION/MIRROR IMAGE REVERSION .................................................. 43
11. REPEAT .............................................................................................................. 44
12. REPEAT (CONVERTED ARRANGEMENT) .................................................. 46
13. EXPLANATION ON THE SCREEN (AUTOMATIC OFFSET) ...................... 47
14. AUTOMATIC OFFSET ...................................................................................... 48
CHAPTER
6
DESIGN DATA MANAGEMENT
1. EXPLANATION ON THE SCREEN (SCREEN 2200) ..................................... 50
2. FLOPPY DISK WRITING ................................................................................. 51
3. OVERWRITING OF DESIGN NAME .............................................................. 52
4. DELETION OF MEMORY DESIGN ................................................................ 53
5. DELETION OF ALL DESIGNS ........................................................................ 54
6. CLEANUP ........................................................................................................... 55
7. EXPLANATION ON THE SCREEN (SCREEN 8000) ..................................... 56
8. FUNCTION SEARCH ........................................................................................ 57
9. INSERTION OF STITCH ................................................................................... 58
10. DELETION OF STITCH .................................................................................... 59
11. MODIFICATION OF STITCH DATA .............................................................. 60
12. EXPLANATION ON THE SCREEN (SCREEN 3000) ..................................... 61
13. DELETION OF DESIGN DATA IN FLOPPY DISK ........................................ 62
14. FORMATTING OF FLOPPY DISK .................................................................. 63
CHAPTER
7
MANUAL OPERATION
1. EXPLANATION ON THE SCREEN (SCREEN 1400) ..................................... 66
2. THREAD TRIMMING/TRACE ......................................................................... 67
3. MANUAL OFFSET/DESIGN START POSITION ........................................... 68
4. FRAME ORIGIN MEMORY (TFHX-II, TFHX-IIC) ........................................ 69
5. FRAME ORIGIN MEMORY (TEHX-C, TFHX, TFHX-C) .............................. 70
6. POWER RESUME (TFHX-II, TFHX-II) ........................................................... 71
7. POWER RESUME (TEHX-C, TFHX, TFHX-C) ............................................... 72
8. AUTOMATIC LUBRICATION SYSTEM (OPTION) ...................................... 73
9. TABLE UP/DOWN DEVICE (TEHX-C) .......................................................... 74
10. SEQUIN DEVICE ............................................................................................... 75
11. FRAME BACK/FORWARD .............................................................................. 76
12. MANUAL COLOR CHANGE (SCREEN 1300) ............................................... 77
CHAPTER
8
PARAMETER SETTING
EXPLANATION ON THE SCREEN ............................................................. 80
1. AUTO COLOR CHANGE (AC) ........................................................................ 81
2. AUTO START (AS) ........................................................................................... 81
3. A.S. IN THE SAME COLOR ............................................................................. 81
4. A. S. AFTER AUTO DATA SET ....................................................................... 81
5. MAIN SHAFT INCHING ................................................................................... 81
6. M.SHAFT INCHING AFTER ATH ................................................................... 82
7. AUTO JUMP [MM] ............................................................................................ 82
8. JUMP CONVERT ............................................................................................... 82
11. FRAME BACK ALL HEAD SEW ..................................................................... 83
12. OVERLAP FRAME BACK ................................................................................ 83
13. HALT FRAME BACK ....................................................................................... 83
15. MIN. REVOLUTION [RPM] ............................................................................. 83
16. UPPER T.DETECTION ...................................................................................... 84
17. UNDER T.DETECTION (UNIT) ....................................................................... 84
18. UNDER T.D. (STEP RATIO) [%] ...................................................................... 84
19. ATH ..................................................................................................................... 84
(GC02)