Takeuchi TB215R - Installing the Blade; Removing the Blade; Installing the Boom Bracket; Removing the Boom Bracket

DISASSEMBLY AND ASSEMBLY
ATTACHMENTS
8
4
ATTACHMENTS 4G0AX001
Removing the boom bracket
1. Take out the pin (31), and disconnect the swing cyl-
inder (32) from the boom bracket.
2. Suspend the boom bracket (27) temporarily and then
pull out the pins and remove the boom bracket.
• Be careful not to damage the hoses when working
with them.
Boom bracket: 30 kg (65 lb)
Installing the boom bracket
To install, follow the same procedures as for removal but
in the reverse order.
• During assembly, apply NEVER-SEEZ NS lubricant (an
anti-seizing lubricant) to the fixing pin holes on the
boom bracket and then insert the pins into the appro-
priate holes.
• Attach the washer (33) with the side with the grease
groove facing upward (toward the boom bracket side).
Removing the blade
Lower the blade all the way down to the ground.
1. Disconnect the hydraulic hoses from the blade cylin-
der (35).
2. Suspend the blade cylinder (35) temporarily and
then pull out the pins and remove the blade cylinder.
Blade cylinder: 11 kg (23 lb)
3. Suspend the blade (34) temporarily and then take
out the pins and remove the blade (34).
Blade: 50 kg (111 lb)
Installing the blade
To install, follow the same procedures as for removal but
in the reverse order.