TallyGenicom Matrix Printer - Character Sets

Character Sets
ESC t
Data Structure
ASCII ESC "t" <d
1
> select character table
hex. 1B 74 <d
1
>
dec. 27 116 <d
1
>
Description Valid values:
0 ≤ d
1
≤ 3, 48 ≤ d
1
≤ 51
By means of this code sequence the upper half of character code table
(dec. 128 to dec. 255) can be selected.
default Description
d
1
= 0 or 48 Character table 0 italic
The Epson Standard Character
Set is selected. The upper half
contains control codes and italic
characters.
d
1
= 1 or 49 Character table 1 Table 437
The Epson Graphic Character Set
is selected. The upper half
contains international and graphic
characters (see IBM Character
Set 2, from hex.A0 to hex.FF)
d
1
= 2 or 50 Character table 2 DLL *)
The upper half contains user-
defined characters, if created by
ESC &. When creating characters,
assign code value in the range of
0 to 127. For using add 128 to the
codes. Using of n = 2 without user-
defined characters causes same
contents of upper and lower half
of the character code table.
d
1
= 3 or 5 Character table 3 Table 437
The IBM Code Page Table 437
is selected
* user defined character set
Miscellaneous
103