TallyGenicom Matrix Printer - Margins; Code MSI; modified Plessey

7265 Programmer’s Manual
21
Copyright © 2004 TallyGenicom Chapter 2 ANSI
Superscript/Subscript
Command Description
ESC K
(PLD)
SUBSCRIPT PRINTING
Moves paper 1/2 line below the current line for subscript printing. ESC K is used to
return to the original line following ESC L (superscript).
If 8-bit control code processing is enabled then
Dec 139 Hex 8B
otherwise
Dec 27 75 Hex 1B 4B
ESC L
(PLU)
SUPERSCRIPT PRINTING
Moves paper 1/2 line above the current line for superscript printing. ESC L is used to
return to the original line following ESC K (subscript).
If 8-bit control code processing is enabled then
Dec 140 Hex 8C
otherwise
Dec 27 76 Hex 1B 4C
NOTE: The partial line up does not respect top of form; that is, following a form feed, ESC L causes a partial line
movement upward. Also, partial line down does not respect bottom of form; that is, when printing the last line on
the form, ESC L causes a partial line movement downward.
When printing the last line on a form, do not send a line feed (LF) code to move directly from superscript to
subscript. The LF code will be acted upon as the bottom of form terminator.