7265 Programmer’s Manual
65
Copyright © 2004 TallyGenicom Chapter 4 ANSI Oversized
Commands Description
ESC
[Pv;Ph<sp>B
SET CHARACTER SIZE
Sets the expansion of oversized characters in percentage points. Pv is the vertical
expansion and Ph is the horizontal expansion. The parent font is a 10-point font.
Dimensions established by this sequence are stored in nonvolatile RAM while power is
off.
Caution: Any text between receipt of this command and a countermanding mode
selection command, either ESC [(Ps)| or ESC[(Ps)t, will be printed in expanded mode.
If you do not want this to happen, then you must follow this command immediately with
a mode selection command.
The range of valid parameters (in the sense that a valid parameter does not abort the
escape sequence) is 0 <= Pn < 32767. The printer rounds off dimension parameters
as follows:
If Pn < 100, then Pn = 100
If 100 < Pn < 18700, then Pn is rounded down to the nearest 100.
If Pn >= 18700, then Pn = 18700
Example - to set 20-point type at 1:1 aspect ratio:
Dec 27 91 50 48 48 59 50 48 48 32 66
Hex 1B 5B 32 30 30 3B 32 30 30 20 42
ESC
[0|
ESC
[p1|
EXIT OVERSIZED
Dec 27 91 48 125
Hex 1B 5B 31 7C
SET OVERSIZED
p1 = 1-4
Dec 27 91 49-52 124
Hex 1B 5B 31-34 7C
To Next Page
Loading...
