Paper and Text Formatting
Form Length CSI ... t
Data Sructure ASCII CSI n "t" [A] set form lenght in lines
hex. 9B n 74
dec. 155 n 116
Description PUM turned OFF:
n = 1...132 lines at a line spacing of
1
⁄
6
inch (6 lpi)
= 1...176 lines at a line spacing of
1
⁄
8
inch (8 lpi)
This MTPL-sequence sets the form length to n times the current line feed pitch (in in-
ches). Also the current print position is simultaneously defined as top of form.
The value specified for n must be in the range 1 to 255. This value is multiplied by the cur-
rent line feed pitch to obtain the form length. For example, if 60 is specified for n and the
current line feed is
1
⁄
6
inch, the form length is set to 10 inches. Once set by this sequence,
the form length is not affected by changing the line spacing.
PUM turned ON:
The unit for n is either the decipoint or defined by the SSU function (Select Size Unit, see
page 8).
n = 0: Reset form lenght to default value.
(print menu setting)
Paper and Text Formatting
5
To Next Page
Loading...
