TallyGenicom Matrix Printer - Page 240

Character explanation and symbol description
Lower case “ ”
Informations
Sequence only applies for 9 needle printer
Sequence only applies for 24 needle printer
In the following you will find an example for a MTPL sequence with a Basic programming
example:
Set to a form length of 72 lines:
MTPL-Sequence CSI n
with n=72
t
Transmission ASCII CSI "72" "t"
hex. 9B 37 32 74
dec. 155 55 50 116
100 REM Sample for the CSI n t sequence in ASCII,
110 REM using formulars with 72 lines.
120 REM Please note, in ASCII-Syntax you can use ASCII values
130 REM equal or bigger codetable no. 32 only.
140 LPRINT CHR$(155);"72";"t": REM mixed syntax;
150 REM set form length up to 72 lines
160 REM The same sequence written in hexadecimal syntax
170 LPRINT CHR$(&H9B);CHR$(&H37);CHR$(&H32);CHR$(&H74);
180 REM set form length up to 12 lines
190 REM The same sequence written in decimal syntax
200 LPRINT CHR$(155);CHR$(55);CHR$(50);CHR$(116);
210 REM set form length up to 72 lines
ll
4 Introduction