TallyGenicom Matrix Printer - Double Height off; Double Height on (Lower Half); Double Height on (Upper Half)

Double Height ON (Upper Half) CSI 12 z
Double Height ON (Lower Half) CSI 13 z
Double Height OFF CSI 2 z
Data Structure ASCII CSI "1" "2" "z" [C] double height ON (upper half) ➊
hex. 9B 31 32 7A
dec. 155 49 50 122
ASCII CSI "1" "3" "z" [C] double height ON (lower half)
➊
hex. 9B 31 33 7A
dec. 155 49 51 122
ASCII CSI "2" "z" [A] double height OFF
➋
hex. 9B 32 7A
dec. 155 50 122
Description
➊ The same character must be sent to both lines to form a full character. Afterwards
double height must be reset. If only a part of the line is printed double height, the posi-
tioning of upper/lower half must be done by spaces. The line spacing should be set to
1
⁄
6
inch.
➋ This sequence also resets superscript, subscript and microscript.
Note: For selection of double height together with the proportional mode or other print
attributes the start of printing has to be identic for the top and bottom half.
Character Styling 29