Taylor-Dunn MX-026-00 - Maintenance, Service, and Repair Hardware Torque

TABLE OF CONTENTS
Chapter -
Front End Alignment, SS-546 ............2
Rod Ends, SS-546.............................3
Inspection .............................................................. 3
Replacing .............................................................. 3
Fork / Steering Shaft Bearings .........4
Replace the Steering Wheel ..............4
Replace the Steering Gear, SS-534...5
Replace the Steering Gear,
SS-536, 546, MX-600 ...................5
Replace the Front Fork .....................6
Hardware Torque ...............................6
Steering Component
Service
5
There are three different steering configurations available depending
on the vehicle model and options ordered. Make sure you are in the
correct section for your vehicle.
Tiller steering is standard on SS-534, SS-536, and MX-600.
Geared steering is optional on SS-534, SS-536, and MX-600.
Geared steering is standard on SS-546.
There are two steering gear assemblies. One for SS-534 and the other
for SS-536, SS-546, and MX-600.