Maintenance, Service, and Repair
Transaxle - SS-536, SS-546, MX-600
Page 3
TRANSAXLE ASSEMBLY
Remove
6. Raise the rear of the vehicle and support with jack
stands.
7. Remove the wheels. Refer to procedure in “Tires
and Wheels” section.
8. Disconnect the motor cables.
9. Disconnect the brake cables.
10. Remove the bolts holding the transaxle assembly
to the springs (model SS), or frame (model MX).
11. Remove the transaxle from the vehicle.
12. Lower the frame to the ground or leave supported
on jack stands.
1. Make sure the start switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the battery connector from the
vehicle.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and support
the vehicle. Failure to use lifting and support
devices of rated load capacity may result in
severe bodily injury.
After the next step, the transaxle will be free
from the vehicle. Be sure the transaxle is
supported so that it does not to the ground.
Install
1. Install the transaxle in reverse order of removal.
• Install the wheels Refer to procedure in Tire/
Wheels section.
• Tighten the motor terminals per torque listed in
the Hardware Torque table at the end of this
section.
2. Adjust he brakes. Refer to procedure in Brake
section.
3. Reconnect the main positive and negative cables
at the batteries, remove blocks from behind the
wheels and test drive the vehicle.
To Next Page
Loading...
