Maintenance, Service, and Repair
Transmission Page 2
CHECK OIL LEVEL
Park the vehicle on a level surface.
6. Place a drain pan that can hold a minimum of
2-quarts of oil under the transmission level plug.
7. Remove the level plug. When the plug is removed, a small amount
of oil should come out. This indicates that the transmission has
the correct amount of oil.
8. If no oil comes out, then add oil as required through the level plug
hole.
9. Reconnect the main positive and negative cables at the batteries.
10. Remove blocks from behind the wheels.
11. Test drive the vehicle
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Transmission Oil Level Plug
To Next Page
Loading...
