TDK-Lambda GENESYS 10KW - Safety Instructions: Environmental Conditions; Environmental Operating Conditions

83
-
530
-
000 Rev.
G
3
SAFETY INSTRUCTIONS
ENVIRONMENTAL CONDITIONS
The Genesys
TM
power supply series safety approval applies to the following operating cond
i
tions:
*Indoor use
*Ambient temperature: 0°C to 50°C
*Maximum relative
humidity: 80% (no condensation)
*Altitude: up to 3000m
*Pollution degree 2
ATTENTION Observe Precautions for handling Electrostatic Sensitive Devices.
CAUTION Risk of Electrical Shock
Instruction manual symbol. The instrument will be marked wi
th this symbol when it is
necessary for the user to refer to the instruction manual.
Indicates hazardous voltage.
Indicates ground terminal.
Protective Ground Conductor Terminal must be connected to Earth Ground.
Off (Supply)
On (Supply)
The WARNING sign denotes a hazard. An attention to a procedure is called.
Not fo
l
lowing procedure correctly could result in personal injury.
A WARNING sign should not be skipped and all indicated conditions mus
t be
fully understood and met.
The CAUTION sign denotes a hazard. An attention to a procedure is called. Not follo
w-
ing procedure correctly could result in damage to the equipment. Do not proceed b
e-
yond a CAUTION sign un
til all indicated conditions are fully understood and met.
FCC COMPLIANCE NOTICE:
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pr
o-
vide reasonable protection against harmful interference when the equipment is ope
r-
ated in a commercial environment. This equipment generates uses, and can radiate
radio frequency energy and, if not installed and used in acco
r
dance with the instruction
man
ual, may cause harmful interference to radio communications. Oper
a
tion of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.