TDK-Lambda GENESYS 10KW - Rear Panel Controls and Indicators; SW1 Setup Switch Functions

83
-
530
-
000 Rev.
G
29
4.3 REAR
PANEL CONTROLS AND INDICATORS
Table 4
-
2: Rear panel connections and controls
Nu
m
ber
Item
Description
Se
c
tion
1
AC input
conne
c
tor
M6 Stud terminal suitable for ring lugs.
3.7.1
3.7.2
2
DC output
Bus
-
bars up to 300V models.
Stud terminals for models above
300V.
3.9.6
3
Remote
-
In
connector
RJ
-
45 type connector, use for connecting power supplies to RS232
or RS485 port of computer for remote control purposes. When u
s-
ing several power supplies in a power sy
s
tem, the first unit Remote
-
In is connected to the co
mputer and the remaining units are
chained, Remote
-
In to R
e
mote
-
Out.
7.3
7.4
4
Remote Out
connector
RJ
-
45 type connector, used for chaining power supplies to form a
serial communication bus.
7.3
7.4
5
J1 Analog
Remote
connector
Connector for remote anal
og interface. Includes output voltage and
current limit programming and monitoring signals, Shut
-
off control
(electrical signal), Enable/Disable control (dry
-
contact), power su
p-
ply ok (PS_OK) signal and operation mode (CV/CC) s
i
gnal.
4.5
6
SW1 Setup
switc
h
Nine position DIP switch for selecting remote programming and
monitoring modes for Output Voltage, Current Limit and other co
n-
trol functions.
4.4
7
J2 Remote
sense co
n-
nector
Connector for making remote sensing connections to the load for
regulation o
f the load voltage and compensation of load wire drop.
8
Blank Sub
-
plate or O
p-
tional IEEE,
ISO Analog
Module or
LAN Module
Blank sub
-
plate for standard units. Isolated Remote Analog pr
o-
gramming connector for units equipped with Isolated Analog control
option. IEEE connector for units equipped with IEEE programming
option (shown). LAN connector for units equipped with LAN pr
o-
gramming option.
9
IEEE switch
LAN switch
Two position DIP switch for selecting option mode or RS232/485
mode. The o
p
tions may
be IEEE or LAN.
10
Ground
screw
M5x20mm screw for chassis ground connection.
4.4
REAR PANEL SW1 SETUP SWITCH
The SW1 Setup switch (see Fig.4
-
3) is a 9
-
position DIP switch that allows the user to choose the fo
l-
lowing:

Internal or remote programming for
Output Voltage and Current Limit.

Remote voltage or resistive programming of Output Voltage and Output Current limit.

Select range of remote voltage and resistive programming.

Select range of output Voltage and Output Current monitoring.

Select the Remote
Shut
-
Off control logic.

Select between RS232 and RS485 communication interface.

Enable or disable the rear panel Enable/Disable control (dry contact).