11
8303460000 Rev A IA672-04-01-Rev. I
3.3.2. Link and Activity LED: this small LED, embedded in the RJ-45 socket, glows green
when the connection is made to an active network and it blinks when any message
packets are detected.
3.3.3. Collision LED: this small LED, embedded in the RJ-45 socket, blinks green when
the LAN packets are corrupted by collisions.
3.3.4. LAN Status LEDs: These are a red LED (top) and a green LED (bottom) to the right
of the RJ-45 connector. They show:
Normal Operation: Steady green LED. The power supply has an active LAN
connection.
Device Identify: Blinking green or red. The identify function is turned on from a
remote computer using the web page or a SCPI command. The front panel blinks
along with the rear. It is used to identify one power supply in a rack of
instruments. The blinking is turned off by the web page, by sending the ‘blink off’
SCPI command, or by changing any front panel control.
In a multi-drop chain of supplies, only the master LAN supply can blink.
LAN Fault: Steady red LED. Shows the LAN mode is not enabled, the LAN
connection was never made, or that the LAN connection was made and then
broken.
To Next Page
Loading...
