7
8303460000 Rev A IA672-04-01-Rev. I
Only one may be opened at a time:
Web page (login as ‘admin), VISA or TCP sockets
Up to four VISA, TCP or UDP sockets may be open at same time
Multiple web pages can be open at once
Identify power supply model, serial number, revision etc.
View and set LAN configuration
Program and read output settings
Send SCPI commands, read errors
Link to TDK-Lambda web sites
Supply may be run from front panel even if LAN is monitoring
Supply may be controlled and monitored through LAN
LAN may be disabled to use the standard RS-232/485 ports
LAN may monitor supply while analog controller sets output
Series / Parallel Supplies
Rules for standard Genesys™ supplies apply to LAN supplies
Rules for standard Genesys™ supplies apply to LAN supplies
View addresses on front panel
View RS-485 address on front panel
Indicates the Ethernet cable connected at both ends
Indicates when LAN packets detected
Red/green, indicates power supply has valid IP connection
Find the supply by remotely blinking front and rear LEDs
Indicates if LAN has control of supply output
Change entire IP address on front panel
Change RS-485 address on front panel
Disable LAN to enable RS-232/485 or Multi-drop slave
Can set password to prevent unauthorized or accidental changes
to LAN settings or power supply output settings
Set to prevent multiple programs from taking control
Single client will block attacks through UDP sockets
Stop power supply detection, reduce network traffic
Stop power supply detection
Stop power supply detection
Certified for LXI rev 1.5 instrument
UL, IEC, TUV,
CE, ROHS etc
Conformances that are granted to basic power supply also apply
to power supply with LAN installed
To Next Page
Loading...
