TDK-Lambda Z+ series - Measure Subsystem; Display Subsystem

100
7.12.5 Measure Subsystem
This subsystem reads the actual voltage and current. The power is a result of multiplying voltage
and current measurements.
MEASure
:CURRent[:DC]?
:VOLTage[:DC]?
:POWer[:DC]?
MEASure:CURR?
Reads the measured output current. Returns a 5 digit string.
SCPI Command Syntax MEASure:CURRent?
GEN Command Syntax MC?
Parameters None
Default Suffix A
Returned Parameters <NR3>
MEASure:VOLTage?
Reads the measured output voltage. Returns a 5 digit string.
SCPI Command Syntax MEASure:VOLTage?
GEN Command Syntax MV?
Parameters None
Default Suffix V
Returned Parameters <NR3>
MEASure:POWer?
Reads the measured output power. Returns a 5 digit string.
SCPI Command Syntax MEASure:POWer?
GEN Command Syntax MP?
Parameters None
Default Suffix W
Returned Parameters <NR3>
7.12.6 DISPlay Subsystem
DISPlay
[:WINDow]:STATus <bool> Display ON/OFF
[:WINDow]:FLASh <bool> Display Flash