13
Questions? Call 1-866-44-TDSTV or visit tdstv.com.
4. Release both buttons. All mode buttons will blink twice.
5. Enter the programming code 9 2 2 using the keypad on the remote control. The mode
button you selected blinks twice to indicate a successful entry.
6. Point the remote toward the device and repeatedly press PLAY (don’t hold it) until the
device powers off.
7. Once powered off, press ENTER on your remote control to save the settings. The mode
button blinks three times indicating a successful entry.
How to automatically search for auxiliary devices
1. Turn on the device you want to assign to the AUX button.
2. Point the remote at the device.
3. Press and hold the AUX and OK buttons at the same time.
4. Release both the AUX and OK buttons. All the mode buttons blink twice.
5. Enter the programming code 9 2 2 using the numbers on the remote. The AUX button blinks
twice to indicate a successful entry.
6. Press the PLAY button, choose one of the following device categories. Use the numbers on
the remote, press the assigned number (1–4) based on the following list:
1 = VCR 2 = Receiver/Tuners
3 = Amplifiers 4 = Home Theatre System
7. Point the remote toward the device and repeatedly press PLAY (don’t hold it) until the device
powers off.
8. Once powered off, press ENTER on your remote control to save the settings. The mode button
blinks three times indicating a successful entry.
How to control power of multiple devices simultaneously
1. Press and hold the STB and OK buttons on the remote.
2. Release both buttons. All mode buttons blink twice.
3. Enter the programming code 9 7 7 using the numbers on the remote control. The STB button
blinks twice to indicate a successful entry.
4. For the first device, press the button of the device you want to program (TV, DVD, or AUX).
The device will blink twice. The press the STB button. The STB button will blink twice.
5. For the second device, press the applicable mode button (TV, DVD, or AUX). The selected
mode button blinks twice.
6. Repeat step 5 for up to two more devices (total of four devices).
7. Press the ENTER button. The last selected mode button blinks 3 times to indicate a successful entry.
How to reset your remote to factory settings
1. Press and hold the STB and OK buttons on the remote.
To Next Page
Loading...
