TEC TECDrive20-EU Series - Braking Resistor Installation

TECDrive20-EU Series Inverter Optional peripheral accessories
-161-
Model
Type of
braking
unit
Braking
resistor at
100% of
braking
torque (Ω)
Consumed power of the braking
resistor (kW)
Min.
braking
resistor
(Ω)
10%
braking
50%
braking
80%
braking
TDI20-0R7G-4-EU
653
0.11
0.56
0.90
240
TDI20-1R5G-4-EU
326
0.23
1.13
1.80
170
TDI20-2R2G-4-EU
222
0.33
1.65
2.64
130
TDI20-004G-4-EU
122
0.6
3
4.8
80
TDI20-5R5G-4-EU
89.1
0.75
4.13
6.6
60
TDI20-7R5G-4-EU
65.3
1.13
5.63
9
47
TDI20-011G-4-EU
44.5
1.65
8.25
13.2
31
TDI20-015G-4-EU
32.0
2.25
11.3
18
23
TDI20-018G-4-EU
27
3
14
22
19
TDI20-022G-4-EU
22
3
17
26
17
TDI20-030G-4-EU
17
5
23
36
17
TDI20-037G-4-EU
13
6
28
44
11.7
TDI20-045G-4-B-EU
10
7
34
54
8
TDI20-055G-4-B-EU
8
8
41
66
8
TDI20-075G-4-B-EU
6.5
11
56
90
6.4
TDI20-090G-4-B-EU
5.4
14
68
108
4.4
TDI20-110G-4-B-EU
4.5
17
83
132
4.4
Note:
 Select the resistor and power of the braking unit according to the data our company
provided.
 The braking resistor may increase the braking torque of the inverter. The resistor power in
the above table is designed on 100% braking torque and 10% braking usage ratio. If the
users need more braking torque, the braking resistor can decrease properly and the power
needs to be magnified.
 Never use a braking resistor with a resistance below the minimum value
specified for the particular drive. The drive and the internal chopper are
not able to handle the overcurrent caused by the low resistance.
 Increase the power of the braking resistor properly in the frequent braking
situation (the frequency usage ratio is more than 10%).
C.7.2 Braking resistor installation
Braking resistor cables need to be shielded cables.All resistors must be installed in places with
good cooling conditions.