TEC TECDrive20-EU Series - Page 86

TECDrive20-EU Series Inverter Function parameters
-81-
Function
code
Name
Description
Default
Modify
Tens place: frequency control selection
0: Valid only when P00.06=0 or P00.07=0
1: All frequency modes are valid
2: When the multi-step speed are priority, it is
invalid to multi-step speed
Hundreds place: action selection when stop
0: Setting is valid
1: Valid in running, clear after stop
2: Valid in running, clear after receiving the stop
commands
P08.45
UP terminal
frequency
increment
integral speed
ratio
0.01–50.00s
0.50 s
○
P08.46
DOWN
terminal
frequency
decrement
integral speed
ratio
0.01–50.00s
0.50 s
○
P08.47
Action
selection at
power loss
0x000–0x111
Ones place: Action of the digital regulation
frequency at power off.
0: Save when power off
1: Clear when power off
Tens place: Action of the set Modbus frequency
at power off
0: Save when power off
1: Clear when power off
Hundreds place: Action of the other
communication frequencies at power off
0: Save when power off
1: Clear when power off
0x000
○
P08.48
High bit of
original power
consumption
value
This parameter is used to set the original value of
the power consumption.
The original value of the power consumption
=(P08.48×1000+ P08.49) kWh
0
○