Advanced
DS-Lite — Check this box to enable the Dual-Stack Lite (DS-Lite) function. DS-Lite is
used to omit IPv4 address deployment from Customer-premises equipment (CPE)
devices but instead use the global IPv6 address provided.
AFTR IPv6 Address — Enter an After Family Transition Router (AFTR) IPv6 address.
Click the Apply button to save your changes or click the Cancel button to discard your
changes.
6.4.3 PPPoE
On My IPv6 Connection is, select PPPoE.
Connection Name — Select an Internet connection to use. This is the connection that
you set up in SETUP > Internet Setup page. See “Internet Setup” on page 21.
PPPOE
Connection Name — Enter the connection name provided by your ISP or a desired
connection name.
Address Mode — Select Dynamic IP or Static IP.
IP Address — If the Address Mode is Static IP, enter the IP address.
Obtain a DNS Server address automatically — Select to obtain the DNS sever
automatically. Available only if the Address Mode is Dynamic IP.
Use the following DNS address — Select to manually set the DNS Server addresses.
When selected, enter the Primary DNS Address and Secondary DNS Address provided
by your ISP.
Wireless ADSL2+ Gateway 50
To Next Page
Loading...
Need help?
General
